Depending on the extent of the damage and the location of the pipe, the restoration process could take several days or weeks and cause a lot of mess, noise, and inconvenience. Fortunately, there is a better way to repair your sewer pipes without digging: trenchless pipe lining. This is a method that uses a flexible tube coated with a resin to create a new lining inside the old pipe. The new lining seals the cracks and joints, and restores the functionality of the pipe.
But how long does this process take? Can trenchless pipe repair in Roswell, GA really be done in a day? Let’s have a look at the main steps involved in trenchless pipe lining.
Initial Inspection: For the evaluation of the extent of damage, and to measure or determine how much material should be used for the restoration.
Cleaning: The first step is to clean the old pipe using a high-pressure water jet or a mechanical device. This removes any debris, grease, or roots that might interfere with the lining process.
Lining: The second step is to insert the lining tube into the old pipe through a small access point. The lining tube is inflated and pushed through the pipe until it reaches the other end.
Curing: The third step is to cure the lining tube in place, using hot water, steam, or UV light. This hardens the resin and forms a new pipe within the old pipe.
Final Inspections and Finishing Touches: The final step is to cut off the excess lining tube and reconnect the pipe to the sewer system. Inspections are carried our to ensure that the new pipe is then ready to use and that the trenchless sewer repair process was a success.
The Time Required for Trenchless Pipe Lining
The time required for trenchless pipe replacement depends on several factors, such as the size, length, and condition of the pipe, the type of resin and curing method used, and the complexity of the access point. However, in general, trenchless pipe lining can be done in a day or less, depending on the scope of the project.
According to some sources, the average time for trenchless sewer replacement is about 4 to 6 hours per 100 feet of pipe. This means that a typical residential sewer line of about 50 feet can be lined in 2 to 3 hours. A commercial sewer line of about 200 feet can be lined in 8 to 12 hours. Of course, these are only estimates, and the actual time may vary depending on the specific situation.
Contact The Pipe Medic for reliable trenchless solutions.
